Dell PowerConnect B-FCX624 Hardware Installation Manual page 52

3
Configuring IP addresses
FIGURE 34
FIGURE 35
Cabling a fiber optic transceiver
Use the following steps to cable a fiber optic transceiver.
1. Remove the protective covering from the fiber-optic port connectors and store the covering for
2. Before cabling a fiber optic transceiver, Dell strongly recommends cleaning the cable
3. Gently insert the cable connector (a tab on each connector should face upward) into the
4. Observe the link and active LEDs to determine if the network connections are functioning
42
Installing a transceiver in PowerConnect B-FCX624s and PowerConnect B-FCX648s
devices
Installing a transceiver in PowerConnect B-FCX624 and PowerConnect B-FCX648
future use.
connectors and the port connectors. For more information, refer to
connectors" on page 43.
transceiver connector until the tabs lock into place.
properly. For more information about the LED indicators, refer to Table 19.
PowerConnect B-FCX Switch Hardware Installation Guide
"Cleaning the fiber optic
53-1002267-01