Configuring Vlans - Cisco HWIC-4ESW - EtherSwitch HWIC Switch User Manual

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
•

Configuring VLANs

This section describes how to configure VLANs on the switch and contains the following sections:
•
•
Adding a VLAN Instance
A total of 15 VLANs can be supported by an EtherSwitch HWIC.
Follow the steps below to configure a Fast Ethernet interface as Layer 2 access.
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
vlan database
Example:
Router# vlan database
Step 3
vlan vlan-id
Example:
Router(vlan)# vlan 1
Step 4
exit
Example:
Router(vlan)# exit
Deleting a VLAN Instance from the Database
You cannot delete the default VLANs for the different media types: Ethernet VLAN 1 and FDDI or
Token Ring VLANs 1002 to 1005.
Managing the EtherSwitch HWIC, page 78
Adding a VLAN Instance, page 6
Deleting a VLAN Instance from the Database, page 6
enable
vlan database
vlan vlan-id
exit
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters VLAN configuration mode.
Adds an Ethernet VLAN.
• Enter the VLAN number.
Updates the VLAN database, propagates it throughout the
administrative domain, and returns to privileged EXEC mode.
How to Configure EtherSwitch HWICs
7