Cisco HWIC-4ESW - EtherSwitch HWIC Switch User Manual page 8

How to Configure EtherSwitch HWICs
Follow the steps below to delete a VLAN from the database.
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
vlan database
Example:
Router# vlan database
Step 3
no vlan vlan-id
Example:
Router(vlan)# no vlan 1
Step 4
exit
Example:
Router(vlan)# exit
Configuring VLAN Trunking Protocol
This section describes how to configure the VLAN Trunking Protocol (VTP) on an EtherSwitch HWIC,
and contains the following tasks:
•
•
•
VTP pruning is not supported by EtherSwitch HWICs.
Note
Configuring a VTP Server
When a switch is in VTP server mode, you can change the VLAN configuration and have it propagate
throughout the network.
Follow the steps below to configure the switch as a VTP server.
8
enable
vlan database
no vlan vlan-id
exit
Configuring a VTP Server, page 7
Configuring a VTP Client, page 8
Disabling VTP (VTP Transparent Mode), page 9
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters VLAN configuration mode.
Deletes an Ethernet VLAN.
Enter the VLAN number.
•
Updates the VLAN database, propagates it throughout the
administrative domain, and returns to privileged EXEC mode.