Cisco HWIC-4ESW - EtherSwitch HWIC Switch User Manual page 25

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Command or Action
Step 4
end
Example:
Router(config-if)# end
Step 5
show dot1x
Example:
Router# show dot1x
Step 6
copy running-config startup-config
Example:
Router# copy running-config startup-config
Changing the Switch-to-Client Retransmission Time
The client responds to the EAP-request/identity frame from the switch with an EAP-response/identity
frame. If the switch does not receive this response, it waits a set period of time (known as the
retransmission time), and then retransmits the frame.
You should change the default value of this command only to adjust for unusual circumstances such as
Note
unreliable links or specific behavioral problems with certain clients and authentication servers.
Follow the steps below to change the amount of time that the switch waits for client notification.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
enable
configure terminal
dot1x timeout tx-period seconds
end
show dot1x
copy running-config startup-config
Purpose
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
How to Configure EtherSwitch HWICs
25