Cisco HWIC-4ESW - EtherSwitch HWIC Switch User Manual page 42

How to Configure EtherSwitch HWICs
Command or Action
Step 4
end
Example:
Router(config)# end
Step 5
show cdp
Example:
Router# show cdp
Enabling CDP on an Interface
Use the steps below to enable CDP on an interface.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface {ethernet | fastethernet}
interface-id
Example:
Router(config)# interface fastethernet 0/1/1
Step 4
cdp enable
Example:
Router(config-if)# cdp enable
42
enable
configure terminal
interface {ethernet | fastethernet}
cdp enable
end
show cdp interface interface-id
show cdp neighbors
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Purpose
Returns to privileged EXEC mode.
Verifies the CDP configuration.
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Selects an interface to configure, and enters interface
configuration mode.
Enter the interface number.
•
Enables CDP globally.