Cisco HWIC-4ESW - EtherSwitch HWIC Switch User Manual page 56

How to Configure EtherSwitch HWICs
Command or Action
Step 6
show ip igmp snooping mrouter [vlan vlan-id]
Example:
Router# show ip igmp snooping mroute vlan
vlan1
Step 7
copy running-config startup-config
Example:
Router# copy running-config startup-config
Configuring Per-Port Storm Control
You can use these techniques to block the forwarding of unnecessary flooded traffic. This section
describes how to configure per-port storm control and characteristics on your router and consists of the
following configuration procedures:
•
•
By default, unicast, broadcast, and multicast suppression is disabled.
Enabling Per-Port Storm Control
Use these steps to enable per-port storm control.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
56
Enabling Per-Port Storm Control, page 56
Disabling Per-Port Storm Control, page 58
enable
configure terminal
interface interface-type interface-number
storm-control {broadcast | multicast | unicast} level level-high [level-low]
storm-control action shutdown
end
show storm-control [interface] [broadcast | multicast | unicast | history]
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Purpose
(Optional) Displays Mroute discovery information.
(Optional) Saves your configuration to the startup
configuration.