Cisco HWIC-4ESW - EtherSwitch HWIC Switch User Manual page 60

How to Configure EtherSwitch HWICs
Command or Action
Step 3
interface fastethernet interface-id
Example:
Router(config)# interface fastethernet
0/3/1
Step 4
no shutdown
Example:
Router(config-if)# no shutdown
Step 5
switchport stacking-partner interface
fastethernet partner-interface-id
Example:
Router(config-if)# switchport
stacking-partner interface FastEthernet
partner-interface-id
Step 6
exit
Example:
Router(config-if)# exit
Step 7
interface fastethernet
partner-interface-id
Example:
Router# interface fastethernet 0/3/1
Step 8
no shutdown
Example:
Router(config-if)# no shutdown
Step 9
end
Example:
Router(config-if)# end
Note Both stacking partner ports must have their speed and duplex parameters set to auto.
If stacking is removed, stacked interfaces will go to shutdown state. Other nonstacked ports will be left
Caution
unchanged.
60
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Purpose
Specifies the port to configure and enters interface configuration
mode.
• Enter the interface number.
Activates the interface.
• This step is required only if you shut down the interface.
Selects and configures the stacking partner port.
Enter the partner interface number.
•
To restore the defaults, use the no form of this command.
•
Returns to privileged configuration mode.
Specifies the partner-interface, and enters interface configuration
mode.
Enter the partner interface number.
•
Activates the stacking partner interface.
Exits configuration mode.