Modifying Ms Network Settings - Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - 09-22-2008 User Manual

1 Server status is shown in the Network settings area.
2 Click ok or cancel.

3.5.2 Modifying MS Network Settings

IMPORTANT: Back up your system immediately after changing the MS or ES IP address. If you
do not back up with the new IP address, and later restore your system, it will restore the previous IP
address which can show an ES error condition and cause authentication problems. See
"Maintenance," on page 114
To modify MS network settings:
Home window>>System configuration>>Management server
WARNING: Changing the MS network settings will cause the network interface to restart.
1 Click edit network settings in the Network settings area.
Figure 3-9
2 Enter the values you want to modify:
Enter a new name in the Host name text field. For example, garp.mycompany.com
NOTE: Select names that are short, easy to remember, have no spaces or underscores, and
the first and last character cannot be a dash (-).
Enter a new address in the IP address text field. For example, 192.168.153.35
Enter a new netmask in the Network mask text field. For example, 255.255.255.0
Enter a new gateway in the Gateway IP address text field. For example
192.168.153.2
Enter one or more DNS resolver IP addresses, separated by commas, semicolons, or
spaces in the DNS IP addresses text box. For example:
10.0.16.100,10.0.1.1
3 Click ok.
52 Novell ZENworks Network Access Control Users Guide
for instructions on backing up and restoring your system.
Management Server Network Settings
Section 3.15,