Table of Contents
Advertisement
4.7 Acting on Selected Endpoints
Once you have filtered the Endpoint activity window and selected which endpoints to take
action on, you can perform the following actions:
Section 4.7.1, "Manually Retest an Endpoint," on page 148
Section 4.7.2, "Immediately Grant Access to an Endpoint," on page 148
Section 4.7.3, "Immediately Quarantine an Endpoint," on page 148
Section 4.7.4, "Clearing Temporary Endpoint States," on page 149
4.7.1 Manually Retest an Endpoint
To manually retest an endpoint:
Home window>>Endpoint activity
1 Select a box or boxes to select the endpoints of interest.
2 Click retest.
4.7.2 Immediately Grant Access to an Endpoint
To immediately grant access to an endpoint:
Home window>>Endpoint activity
1 Select a box or boxes to select the endpoints of interest.
2 Click change access.
3 Select the Temporarily grant access for radio button.
4 Select minutes, hours, or days from the drop-down list.
5 Enter the number of minutes, hours, or days that the endpoint is allowed access.
6 Click ok.
TIP: To quarantine again, select the endpoint, click change access, select Clear temporary access
control status, and click ok.
NOTE: If an endpoint that has been granted or denied access temporarily by the administrator
disconnects, the next time the endpoint attempts to connect it will be retested; the previous
temporary status no longer applies.
4.7.3 Immediately Quarantine an Endpoint
To immediately quarantine an endpoint:
Home window>>Endpoint activity
1 Select a box or boxes to select the endpoints of interest.
2 Click change access.
148 Novell ZENworks Network Access Control Users Guide
Advertisement
Table of Contents
