Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 599

The configuration of T-DSL is very similar to the DSL setup. Just select T-Online as
your provider and YaST opens the T-DSL configuration dialog. In this dialog, provide
some additional information required for T-DSL—the line ID, the T-Online number,
the user code, and your password. All of these should be included in the information
you received after subscribing to T-DSL.
30.4.6 IBM System z: Configuring Network
Devices
SUSE Linux Enterprise for IBM System z supports several different types of network
interfaces. YaST can be used to configure all of them.
The qeth-hsi Device
To add a qeth-hsi (Hipersockets) interface to the installed system, start the YaST
network card module (Network Devices > Network Card). Select one of the devices
marked IBM Hipersocket to use as the READ device address and click Configure. In
the Network address setup dialog, specify the IP address and netmask for the new inter-
face and leave the network configuration by pressing Next and Finish.
The qeth-ethernet Device
To add a qeth-ethernet (IBM OSA Express Ethernet Card) interface to the installed
system, start the YaST network card module (Network Devices > Network Card). Select
one of the devices marked IBM OSA Express Ethernet Card to use as the READ device
address and click Configure. Enter the needed port name, some additional options (see
the Linux for IBM System z: Device Drivers, Features, and Commands manual for ref-
http://www.ibm.com/developerworks/linux/linux390/
erence at
documentation_novell_suse.html), your IP address, and an appropriate
netmask. Leave the network configuration with Next and Finish.
The ctc Device
To add a ctc (IBM parallel CTC Adapter) interface to the installed system, start the
YaST network card module (Network Devices > Network Card). Select one of the devices
marked IBM parallel CTC Adapter to use as your read channel and click Configure.
Basic Networking 581