Installed System - Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual

z/VM Installation
Log in to the VM guest (see Example "Configuration of a z/VM Directory" (↑Ar-
chitecture-Specific Information) for the configuration) as LINUX1 and proceed to
IPL the installed system:
IPL 151 CLEAR
151 is an example address of the DASD boot device, replace this value with the
correct address.
If using a ZFCP disk as the boot device, specify both the ZFCP WWPN and LUN
of the boot device before initiating the IPL. The parameter length is limited to eight
characters. Longer numbers must be separated by spaces:
SET LOADDEV PORT 50050763 00C590A9 LUN 50010000 00000000
Finally, initiate the IPL:
IPL FC00
FC00 is an example address of the ZFCP adapter, replace this value with the correct
address.
3.13.2 IBM System z: Connecting to the

Installed System

After IPLing the installed system, establish a connection with it to complete the instal-
lation. The steps involved in this vary depending on the type of connection used at the
outset.
Using VNC to Connect
A message in the 3270 terminal asks you to connect to the Linux system using a VNC
client. This message is easily missed, however, because it is mixed with kernel messages
and because the terminal process might quit before you become aware of the message.
If nothing happens for five minutes, try to initiate a connection to the Linux system
using a VNC viewer.
If connecting using a Java-capable browser, enter the complete URL, consisting of the
IP address of the installed system along with the port number, in the following fashion:
Installation with YaST 35