Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 234

1 Insert the SUSE Linux Enterprise SP CD 1 or DVD 1 and boot your machine.
2 Select Installation to boot the SP kernel then use F3 to select a type of network
3 Provide the appropriate path information or select SLP as the installation source.
4 Select the appropriate installation server from those offered or use the boot options
Network Installation—PXE Boot
To perform a network installation of a SUSE Linux Enterprise Service Pack via network,
proceed as follows:
1 Adjust the setup of your DHCP server to provide the address information needed
2 Set up a TFTP server to hold the boot image needed for PXE boot.
3 Prepare PXE boot and Wake-on-LAN on the target machine.
4 Initiate the boot of the target system and use VNC to remotely connect to the
5 Accept the license agreement then select a language, default desktop, and other
6 Click Yes, Install to start the installation.
216 Installation and Administration
A boot screen similar to the original installation of SUSE Linux Enterprise 10
is displayed.
installation source (FTP, HTTP, NFS, or SMB).
prompt to provide the type of installation source and its actual location as in
Section 3.3.4, "Installing from a Network Source without SLP" (page 20). YaST
starts.
Finish the installation as outlined in Chapter 3, Installation with YaST (page 17).
for PXE boot according to Section 4.3.5, "Preparing the Target System for PXE
Boot" (page 75).
Use the first CD or DVD of your SUSE Linux Enterprise Service Pack for this
and otherwise follow the instructions in Section 4.3.2, "Setting Up a TFTP
Server" (page 68).
installation routine running on this machine. See Section 4.5.1, "VNC Installation"
(page 81) for more information.
installation settings.