Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 584

Hide thumbs Also See for LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION:
Table of Contents

Advertisement

The upper part of the next dialog shows a list with all the network cards available for
configuration. Any card properly detected is listed with its name. To change the confi-
guration of the selected device, click Edit. Devices that could not be detected can be
configured using Add as described in Section "Configuring an Undetected Network
Card" (page 571).
Figure 30.3 Configuring a Network Card
Changing the Configuration of a Network Card
To change the configuration of a network card, select a card from the list of the detected
cards in the YaST network card configuration module and click Edit. The Network
Address Setup dialog appears in which to adjust the card configuration using the Address
and General tabs. For information about wireless card configuration, see Section 29.1.3,
"Configuration with YaST" (page 538).
Configuring IP Addresses
When possible, wired network cards available during installation are automatically
configured to use automatic address setup, DHCP.
566
Installation and Administration

Advertisement

Table of Contents
loading

This manual is also suitable for:

Suse linux enterprise server 10 sp3

Table of Contents