Dell 5324 - PowerConnect Switch User Manual Addendum page 5

Updates Interval (5-32768) — Indicates that rate at which LLDP advertisement updates are sent. The
possible field range is 5 - 32768 seconds. The default value is 30 seconds.
Hold Time (2-10) — Indicates the amount of time that LLDP packets are held before the packets are dis-
carded. The possible field range is 2 - 10 seconds. The field default is 4 seconds.
Reinitializing Delay (1-10) — Indicates the amount of time that passes between disabling LLDP and when
reinitializing begins. The possible field range is 1 - 10 seconds. The field default is 2 seconds.
Transmit Delay (1-8192) — Indicates the amount of time that passes between successive LLDP frame trans-
missions due to changes in the LLDP local systems MIB. The possible field value is
1 – 8192 seconds. The field default is 2 seconds.
Configuring LLDP Using CLI Commands
Table 1-1. LLDP Properties CLI Commands
CLI Command
lldp enable (global)
lldp hold-multiplier number
lldp reinit-delay Seconds
lldp tx-delay Seconds
The following is an example of the CLI commands:
Console(config)# interface ethernet g5
Console(config-if)# lldp enable
Description
Enables enable Link Layer Discovery
Protocol.
Specifies the time that the receiving
device should hold a Link Layer
Discovery Protocol (LLDP) packet
before discarding it.
Specifies the minimum time an LLDP
port will wait before reinitializing.
Specifies the delay between successive
LLDP frame tr.ansmissions.
5