Removing Snmp Groups; Defining Snmp Access Control Using Cli Commands - Dell 5324 - PowerConnect Switch User Manual Addendum

Removing SNMP Groups

1 Open the Access Control Group page.
2 Click Show All. The Access Table opens.
3 Select an SNMP group.
4 Check the Remove checkbox.
5 Click Apply Changes.

Defining SNMP Access Control Using CLI Commands

The following table summarizes the equivalent CLI commands for defining fields displayed in the Access
Control Group page.
Figure 1-15. SNMP Access Control CLI Commands
CLI Command
snmp-server group
groupname {v1 | v2 |
v3 {noauth | auth |
priv}} [read
readview ] [write
writeview ] [notify
notifyview ]
show snmp groups
[ groupname ]
The following is an example of the CLI commands:
console (config)# snmp-server group user-group v3 priv read user-
view
The SNMP group is deleted, and the device is updated.
Description
Configure a new Simple Network Management
Protocol (SNMP) group, or a table that maps
SNMP users to SNMP views.
Displays the configuration of groups.
23