Pnp/Pci Configuration Setup - JETWAY 615DFR1A User Manual

power down mode.
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
FDD, COM, LPT Port
PCI PIRQ[A-D] #

3-9 PnP/PCI Configuration Setup

This section describes configuring the PCI bus system. PCI, or Personal Computer Interconnect, is a
system which allows I/O devices to operate at speeds nearing the speed the CPU itself uses when
communicating with its own special components. This section covers some very technical items and it
is strongly recommended that only experienced users should make any changes to the default settings.
CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
Reset Configuration Data
Resources Controlled By
> IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ for VGA
Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
¡ ü ¡ ý ¡ ú ¡ û
F5:Previous Values
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended System Configuration Data
(ESCD) when you exit Setup if you have installed a new add-on and the system reconfiguration has
caused such a serious conflict that the operating system can not boot. The settings are: Enabled and
Disabled.
Resource Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot and Plug
and Play compatible devices. However, this capability means absolutely nothing unless you are using
a Plug and Play operating system such as Windows  95/98. If you set this field to "manual" choose
specific resources by going into each of the sub menu that follows this field (a sub menu is preceded
by a ">").
The settings are: Auto(ESCD), Manual.
IRQ Resources
When resources are controlled manually, assign each system interrupt a type, depending on
the type of device using the interrupt.
DMA Resources
PnP/PCI Configurations
Disabled
Manual
Press Enter
Disabled
Enabled
F6:Optimized Defaults F7:Standard Defaults
37
Item Help
Menu Level >
Default is Disabled.
Select Enabled to
reset Extended System
Configuration Data
ESCD when you exit
setup if you have
installed a new add-on
and the system
reconfiguration has
caused such a serious
conflict that the os
cannot boot
F1:General Help