Table of Contents
Advertisement
your computer, this feature requires an ATX power supply that can supply at least
300mA on the +5VSB lead. The default is set on disable.
3. Clear Keyboard Power On password setting (3-pin) : JB1
You can set keyboard power on function password to assure computer security to
setting password through BIOS SETUP, and you can clear keyboard power on
password by JB1.
4. CMOS RAM Clear (3-pin) : JBAT
A battery must be used to retain the motherboard configuration in CMOS RAM
short 1-2 pins of JBAT to store the CMOS data.
To clear the CMOS, follow the procedure below:
1.
Turn off the system and unplug the AC power
2.
Remove ATX power cable from ATX power connector
3.
Locate JBAT and short pins 2-3 for a few seconds
4.
Return JBAT to its normal setting by shorting pins 1-2
5.
Connect ATX power cable back to ATX power connector
Note: When should clear CMOS
1. Troubleshooting
2. Forget password
3. After over clocking system boot fail
JK1
1
3
1-2 closed : Disabled (default)
Keyboard Power On Function
JB1
1
3
1-2 closed : Normal (default)
Clear Keyboard Power On Password Setting
8
JK1
1
3
2-3 closed : Enabled
JB1
1
3
2-3 closed : Clear Setting
Advertisement
Table of Contents
