Pnp/Pci Configuration Setup - JETWAY J-Mark J-530CF Manual

Hide thumbs

Table of Contents

This section describes configuring the PCI bus system. PCI, or Personal Computer

Interconnect, is a system which allows I/O devices to operate at speeds nearing the

speed the CPU itself uses when communicating with its own special components. This

section covers some very technical items and it is strongly recommended that only

experienced users should make any changes to the default settings.

Resources Controlled By : Manual

Reset Configuration Data: Disabled

IRQ-3 assigned to : PCI/ISA PnP

IRQ-4 assigned to : PCI/ISA PnP

IRQ-5 assigned to : PCI/ISA PnP

IRQ-7 assigned to : Legacy ISA

IRQ-9 assigned to : PCI/ISA PnP

IRQ-10 assigned to : PCI/ISA PnP

IRQ-11 assigned to : PCI/ISA PnP

IRQ-12 assigned to : PCI/ISA PnP

IRQ-14 assigned to : Legacy ISA

IRQ-15 assigned to : Legacy ISA

DMA-0 assigned to : PCI/ISA PnP

DMA-1 assigned to : PCI/ISA PnP

DMA-3 assigned to : PCI/ISA PnP

DMA-5 assigned to : PCI/ISA PnP

DMA-6 assigned to : PCI/ISA PnP

DMA-7 assigned to : PCI/ISA PnP

• Resource controlled by :

The Award Plug and Play BIOS has the capacity to automatically configure all of the

boot and Plug and Play compatible devices.

absolutely nothing unless you are using a Plug and Play operating system such as

Windows®95.

The choice: Auto, Manual.

• Reset Configuration Data:

Normally, you leave this field Disabled. Select Enabled to reset Extended System

Configuration Data (ESCD) when you exit Setup if you have installed a new add-on

and the system reconfiguration has caused such a serious conflict that the operating

system can not boot.

The choice: Enabled, Disabled .

• IRQ3/4/5/9/10/11/12/13/15:

When resources are controlled manually, assign each system interrupt as one of the

following types, depending on the type of device using the interrupt:

Legacy ISA Devices compliant with the original PC AT bus specification, requiring a

specific interrupt ( such as IRQ4 for serial port 1). PCI/ISA PnP Devices compliant

with the Plug and Play standard, whether designed for PCI or ISA bus architecture.

The choice: Legacy ISA, PCI/ISA PnP.

• DMA0/1/3/5/6/7 assigned to:

ROM PCI/ISA BIOS (2A5IMJ1A)