Table of Contents
Advertisement
Auto Detect DIMM/PCI Clk
Spread Spectrum
** Current Host Clock is 100 Mhz **
CPU Host/SDRAM/PCI Clock
CPU Clock Ratio
Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
¡ ü ¡ ý ¡ ú ¡ û
F5:Previous Values
Auto Detect DIMM/PCI Clk
This item allows you to enable/disable auto detect DIMM/PCI Clock.
The settings are: Enabled, Disabled.
Spread Spectrum
This item allows you to set the Spread Spectrum.
CPU/SDRAM/PCI Clock
This item allows you to select the CPU/SDRAM/PCI Clock, refer to
By press PageDown/PageUp key you can change the CPU Host/SDRAM/PCI Clock
When jumper setting CPU Host Clock 66MHz you can choose 66/100/33∼99/133/49MHz
When jumper setting CPU Host Clock 100MHz you can choose 100/100/33∼132/132/44MHz
When jumper setting CPU Host Clock 133MHz you can choose 133/133/33∼200/200/50MHz
CPU Clock Ratio
This item allows you to select the CPU ratio.
3-12 Load Standard/Optimized Defaults
Load Standard Defaults
When you press <Enter> on this item, you get confirmation dialog box with a message similar
to:
Load Standard Defaults (Y/N)? N
Pressing <Y> loads the BIOS default values for the most stable, minimal-performance system
operations.
Load Optimized Defaults
When you press <Enter> on this item, you get a confirmation dialog box with a message
similar to:
Load Optimized Defaults (Y/N)? N
Pressing <Y> loads the default values that are factory settings for optimal performance system
operations.
3-13 Set Supervisor/User Password
You can set either supervisor or user password, or both of them. The differences are:
Supervisor password:
User password:
Enabled
Disabled
100/100/33Mhz
X 3
F6:Optimized Defaults F7:Standard Defaults
Can enter and change the options of the setup menus.
Can only enter but do not have the right to change the options of the
39
Item Help
Menu Level >
F1:General Help
Page
12.
Advertisement
Table of Contents
