JETWAY 615DFR1A User Manual page 39

This determines the manner in which the monitor is blanked. The settings are: Yes and No.
Suspend Type
Select the Suspend Type.
The settings are: PWRON Suspend, Stop Grant.
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Suspend Mode
When enabled and after the set time of system inactivity, all devices except the CPU will be
shut off.
The settings are: l/2/4/8/12/20/30/40 Min, 1 Hour, and Disabled.
HDD Power Down
When enabled and after setting time of system inactivity, the hard disk drive will be powered
down while all the other devices remain active.
The settings are: 1/2/3/4/5/6/7/8/9/10/11/12/13/14/15 Min and Disabled.
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.
Wake Up by PCI card
This will enable the system to wake up to PCI LAN Card.
The settings are: Enabled and Disabled.
Power On by Ring
During Disabled, the system will ignore any incoming call from the modem. During Enabled,
the system will boot up if there's an incoming call from the modem.
CPU Thermal-Throttling
Select the CPU THRM-Throttling rate. The settings are: 12.5%, 25.0%, 37.5%, 50.0%,
62.5%, 75.0%, 87.5%.
Resume by Alarm
This function is for setting date and time for your computer to boot up. During Disabled, you
cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to the
operating system, before this function will work.
PM Timer Reload Events
Pm Timer Reload events are I/O events whose occurrence can prevent the system from entering a
power saving mode or can awaken the system from such a mode. In effect, the system remains alert
for anything which occurs to a device which is configured as Enabled, even when the system is in a
36