Headers - JETWAY 615DFR1A User Manual

setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
(11) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure two
hard disks to be both Masters using one ribbon cable on the primary IDE connector and
another ribbon cable on the secondary IDE connector.
•
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.

2-6-2 Headers

(1) COM2 Headers (10-pin) : COM2
This board has another serial port COM2, it come with cable providing serial port
COM2.
(2) USB Port Headers (10-pin) : USB1
These headers are used for connecting the additional USB port plug. By attaching an
option USB cable, your can be provided with two additional USB plugs affixed to the
back panel.
IDE2
Pin 1
Secondary IDE Connector
Note: Orient the read marking on the
Pin 1
COM2
17
IDE1
Pin 1
Primary IDE Connector
COM2 ribbon cable to pin 1