Table of Contents
Advertisement
2-3-3 Install CPU
This motherboard provides a ZIF socket 370.
motherboard should have a cooling FAN attached to prevent overheating. If this is not
the case, then purchase a correct cooling FAN before you turn on your system.
WARNING! Be sure that there is sufficient air circulation across the processor's
heatsink and CPU cooling FAN is working correctly, otherwise it
may cause the processor and motherboard overheat and damage, you
may install an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF
socket and open it by first pulling the level sideways away from the socket then
upward to a 90-degree angle. Insert the CPU with the correct orientation as shown
below. The notched corner should point toward the end of the level. Because the CPU
has a corner pin for two of the four corners, the CPU will only fit in the orientation as
shown.
When you put the CPU into the ZIF socket. No forces require to insert of the CPU,
then press the level to locate position slightly without any extra force.
2-3-4 Over clock Running
WARNING! This section is for experienced motherboard installer only. Over
clocking can result in system instability or even shortening life of the
processor.
After setting the Jumper JS1, JS3 you can choose over clock running by BIOS CMOS
SETUP UTILITY.
"Miscellaneous Control" you will see the screen as below then.
You can choose the situation you want to try.
Pentium
Colden Arrow
CPU ZIF Socket 370
When you entered CMOS SETUP UTILITY, choose
11
The CPU that comes with the
Intel
III
Advertisement
Table of Contents
