RayTek MX4 User Manual

- Windows®-compatible computer (operating system NT,
Infrared Thermometer with LinTech* Bluetooth® module
- Bluetooth system fully installed on the computer (not inc
This infrared thermometer allows wireless data transfer with the aid of Bluetooth technology.
- BlueTool configuration software (included)
System requirements:
- Windows®-compatible computer (operating system NT, 2000, XP or higher)
After the Bluetooth system has been installed as required
- Bluetooth system fully installed on the computer (not included)
- BlueTool configuration software (included)
different modes:
After the Bluetooth system has been installed as required on the computer, the thermometer can be operated in two
different modes:
1. Passive (Slave) Mode
In this mode, the thermometer is constantly activated
and is searched for by the computer. This is advanta-
geous when continuous temperature monitoring should
In this mode, the thermometer is constantly activated
take place.
Attention: As a result of continuous operation, the thermometer's
and is searched for by the computer. This is advanta-
batteries are discharged much faster then during intermittent use.
geous when continuous temperature monitoring should
Proceed as follows:
1. Switch on the thermo-
take place.
meter with the measurement
button.
Attention: As a result of continuous operation, the thermometer's
2. Press the Setup
batteries are discharged much faster then during intermittent use.
button at the side. The words
"Bluetooth on-up, off-down"
appear on the display.
Activate Bluetooth with the
button below the display. A Proceed as follows:
lightning symbol in the display
indicates that the Bluetooth
1. Switch on the thermo-
module is ready - the lock
symbol signals continuous operation.
meter with the measurement
Note: If the automatic battery test finds that the battery is too weak
here (display: "LowBat - no BT"), the Bluetooth application is not
started.
button.
2. Press the Setup
* Please refer to the LinTech specifications overview for the exact specification of the Bluetooth module used.
button at the side. The words
"Bluetooth on-up, off-down"
appear on the display.
Activate Bluetooth with the
button below the display. A
lightning symbol in the display
indicates that the Bluetooth
module is ready - the lock
symbol signals continuous operation.
Note: If the automatic battery test finds that the battery is too weak
here (display: "LowBat - no BT"), the Bluetooth application is not
started.
1. Passive (Slave) Mode
3. Now start the Bluetooth software on your computer
and allow it to search for and
connect the Bluetooth devices.
(Please refer to the relevant operating
instructions for how this happens in the
case of your Bluetooth application)
4. The thermometer is recog-
nized as "IR Therm....". The
requested PIN is "1234" when
the unit is delivered. With the
right mouse button, click on the
symbol for the device and select
"Properties" in the submenu.
Make a note of the ComPort's
number. The green LED on the
left above the thermometer's
display signals the existing con-
nection.
Up
5. If you have not already done
so, now start the relevant
application software for the
thermometer. Before you can exchange data between
the thermometer and computer, you must set in this
software the number of the ComPort found under Point 4.
Up