Phasing; Mounting Procedures - AMX PRO-DP16 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL Instruction Manual

Phasing

If you experience erratic ramping with your lights, it is possible that the dimmer control card could
be wired out of phase. Check and correct power wiring and repeat the Preset test steps (see
Testing).
If the green PROlink status LED stays on, or nothing happens when the Presets are selected, check
the Pack number value on the dimmer control card. Set the dimmer control cards to different Pack
numbers by using the PROlink DIP switch (SW2) to set the Pack number. Refer to the Sample
Wiring Diagram section on page 13 for details.

Mounting Procedures

FIG. 5 shows the mounting dimensions and the wall cutout dimensions for the PRO-DP16. AMX
recommends mounting the PRO-DP16 in a standard two-gang wallbox.
Cutout
4.68"
(118.87 mm)
.125 R
(3.175 mm)
(Max.)
FIG. 5 Mounting and cutout dimensions
1. Use the cutout dimension shown in FIG. 5 to cutout the install surface for the PRO-DP16.
2. Confirm that the terminal end of the PROlink cable is disconnected, and not receiving power.
3. Gently remove the bezel from the wallplate.
4. Plug in the panel.
5. Place the panel in the wallbox; align the screw holes with the mounting holes on the panel.
Fasten the panel to the wallbox using the screws supplied.
6. Install the overlay.
7. Snap the wallplate back on the bezel.
PRO-DP16 Decor 16-Button PROlink Wall Panel
4.745" (120.5 mm)
REF
3.612" (91.74 mm)
2.712"
(68.88 mm)
0.90"
(22.86 mm)
Install unit using
supplied #6-32
machine screws
at these locations.
.30"
(7.7 mm)
From surface
3.281"
2.80" (83.34 mm)
(71.12 mm)
Wallplate
Mounting bezel
Wiring and Installation
1.42"
(36.1 mm)
Max.
Depth
Bezel
11