Low-End Mode; Recording Low-End Settings - AMX PRO-DP16 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL Instruction Manual

For example, to select curve 10 (Non-dim in the following chart) you must press "1",
then "0", then "Off". Pressing "10" then "Off" does not work.
5. Press Off (pushbutton 12) to record the Dimmer Curve setting.
6. The panel automatically exits Curve Select mode.
Dimmer Curves and Keypad Values
Curve number Keypad number Description
1
2
3
4
5
6
7
8
9
N
O
F
A
B
C
D
E

Low-End Mode

The panel must be in Low-End mode in order to record low-end settings for the Packs. To enter
Low-End mode:
1. Enter Program mode (indicated by the PGM LED).
2. Press Mode (pushbutton 16) three times.
3. Low End mode is indicated by the LE LED.

Recording Low-End settings

1. Select the Pack that you want to record Low-End settings for.
2. Select the Channel that you want to record Low-End settings for on.
3. Enter Program mode (indicated by the PGM LED).
4. Enter Low-End mode (indicated by the LE LED).
5. Use the pushbuttons to enter a number between 0 and 99, to specify the low-end setting for the
selected channel, in percentage points.
For example, press pushbutton 6 for 6%; press pushbuttons 1 then 5 for 15%.
6. Press Off (pushbutton 12) to record the low-end setting.
PRO-DP16 Decor 16-Button PROlink Wall Panel
1 Standard Curve
2 Economy Curve
3 Advance MARK VII ballast
4 PRESCOLITE Intellect ballast
5 % Rolloff
6 % Roll Off
7 30 % Roll Off
8 Advance MARK X ballast
9 50% Roll Off; Fans
10 NON-DIM
11 Always Off
12 Always On
13 Modified Standard Curve
14 Transformer 1
15 Transformer 2
16 Slow Fade, High End
17 MDM module
Panel Programming/Operation
23