Setting The Internal Jumper Communication Mode - AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual

Pre-Installation

Setting the Internal Jumper Communication Mode

1. Locate jumpers J6, J7, and J8 communication mode jumpers on the Mother PCB (FIG. 9). The
connectors and the main board are mounted onto the pan base.
2. Set the jumpers for either AXlink or RS-232 communication.
FIG. 9 Communication mode jumpers J6, J7, and J8 (factory default set to AXlink)
3. Set the jumpers for either AXlink or RS-232 communication.
Jumper Settings (top view)
AXlink (pins 1 & 2)
Jumper 8
Jumper 7
Jumper 6
Pin #s 1 2 3
For RS232 stand-alone mode, the 8-position AXlink Device DIP switch must be set to
all off (down position).
4. Carefully place the cover back onto the main unit by sliding it over the internal gears and
motherboard.
5. Align the Control panel screw holes. Make sure the cables are not pinched in the back panel or
drive gears.
6. Insert the 14 BHSC screws and tighten securely using the 1/16" Allen wrench.
7. Carefully insert the connector panel, on the PT15, into the opening on the side of the unit and
connect it to the motherboard located inside the unit.
8. Firmly secure the control panel to the motherboard.
10
Jumper
locations
J8
(3 pair)
J6
Lens control
section
RS-232 (pins 2 & 3)
Jumper 8
MOTOR
Jumper 7
Jumper 6
J6, J7, and J8
communication
mode settings
MOTOR
Pin #s 1 2 3
AXB-PT15 PosiTrack Camera Controller