Pre-Installation - AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual

Pre-Installation

There are four SPDT slide switches in the lens control section (FIG. 3). Three of the switches
toggle the lens control selection between servomotor or motor mode hardware for control of zoom,
focus, and iris. The fourth selects between ± 6 VDC and ± 12 VDC control for motor mode lens
functions.
An SPDT switch is a Single Pole-Double Throw switch. This switch is completed at
both positions. An example is the Volt switch that is active in both the 6 and 12
positions.
Each PosiTrack unit consists of two main Printed Circuit Boards (PCBs):
The following table shows the necessary tools when working on the PosiTracks.
Necessary Tools
AXB-PT15
3/32 HEX KEY
3/16 HEX KEY
1/16 HEX KEY
5/64 HEX KEY
3/32 HEX KEY
AXB-PT15 PosiTrack Camera Controller
PosiTrack Processor PCB (PosiTrack Mother Board) contains the main processor,
2MB FlashROM, and 2MB SRAM.
PosiTrack Power Management PCB (PosiTrack Daughter Board) contains power
conditioning circuitry, control outputs/inputs to the pan/tilt drives, and zoom/focus/iris
outputs, and inputs to the lenses.
Camera Alignment Peg
Camera Mount Screw
Cover Screws and Connector
Bezel
Tilt Arm Screws
Camera Mount ADJ. Screws
Pre-Installation
5