KYMCO GRAND DINK 125 Service Manual page 8

1
. GENERAL INFORMATION
n After clamping, check each wire to make
sure it is secure.
n Do not squeeze wires against the weld or
its clamp.
n After clamping, check each harness to make
sure that it is not interfering with any
moving or sliding parts.
n When fixing the wire harnesses, do not
make it contact the parts which will
generate high heat.
n Route wire harnesses to avoid sharp edges
or corners. Avoid the projected ends of
bolts and screws.
n Route wire harnesses passing through the
side of bolts and screws. Avoid the
projected ends of bolts and screws.
No Contact
n Route harnesses so they are neither
pulled tight nor have excessive slack.
n Protect wires and harnesses with electrical
tape or tube if they contact a sharp edge or
corner.
n When rubber protecting cover is used to
protect the wire harnesses, it shall be
installed securely.
n Do not break the sheath of wire.
n If a wire or harness is with a broken sheath,
repair by wrapping it with protective tape
or replace it.
n When installing other parts, do not press or
squeeze the wires.
Do not press or squeeze
the wire
GRAND DINK 125/150
Do not pull
too tight
1-6