Adobe AUDITION 3 User Manual page 132

See also
"Applying effects in Edit View" on page 106
"Applying effects in Multitrack View" on page 107
"Use effect presets" on page 104
"Add preroll and postroll to effects previews" on page 107
Multitap Delay options
Displays the different delay units and their settings in the format: Delay [delay time] at [Offset]
Delay Units
([Feedback percentage]). Select a delay unit in the list to adjust its delay settings. Click Add New to create a new Delay
Unit with the current Delay Settings. Click Remove to delete the selected Delay Unit.
Lets you adjust the following delay parameters for each unit:
Delay
•
Adjusts the point in the delay line from which Adobe Audition takes the audio. It is then mixed into
Delay Offset
an earlier point in the delay line, which causes echoing. Keep in mind that it's the relative positions of the offsets of
the delay units that make a difference, not their absolute position. For instance, if you have two delay units at offsets
of 200 and 500, the resulting audio sounds the same as if they were at 100 and 400. The difference between the offsets
is what is important.
• Specifies the number of milliseconds to wait before feeding the audio back into the delay line. The
Delay Time
result is an echo with a period of the delay given to be generated. With several delay units of varying delays added,
the final echo pattern can become very complex. Very short delays give ringing or robotic sounding events. Longer
delays give more distinct echoes.
•
Represents the percentage of the original signal to feed back into the delay line. If the feedback is set
Feedback
too high, ringing and feedback occur. The audio gets louder and louder until it clips and becomes distorted.
However, sometimes you may want this effect, which is similar to the feedback you hear when a live microphone is
set too close to a loudspeaker. If the feedback percentage is too low, then not very much of the original signal is fed
back into the loop. This results in a very subtle effect.
•
Helps prevent the DC component from getting out of hand (the waveform tending upwards or
Allpass Feedback
downwards until it clips). With the option selected, audio from the destination of the delay loop is mixed back into
audio from the originating delay offset. Instead of going one way (from the offset back a certain number of milli-
seconds), it also goes from the destination up to the source, creating a sort of forward feedback, or "feed-forward. "
This setting is handy when designing reverb effects.
Low Cut Filter and High Cut Filter
the low frequencies, depending on the Cutoff and Boost settings. High Cut Filter reduces or boosts the high
frequencies, making each successive echo filtered slightly differently for interesting effects. The Low Cut Filter and
High Cut Filter provide two options:
•
Determines which frequencies are affected. Frequencies below this setting are affected by the Low Cut
Cutoff
Filter. Frequencies above this setting are affected by the High Cut Filter. Changes in the cutoff value affect the tone
of the echoes, as more or less of the frequencies are affected by the filter.
•
Sets the amount of filtering. Gain settings are usually negative, which means the audio is reduced in the
Gain
affected frequency range. Lower negative values result in more audio being cut. Positive values result in boosted
frequencies.
Filter the audio being fed back into the delay line. Low Cut Filter reduces or boosts
ADOBE AUDITION 3.0 127
User Guide