Adobe AUDITION 3 User Manual page 129

"Control effects settings with graphs" on page 104
"Use effect presets" on page 104
Dynamic Delay options
Mixes in the desired amounts of original and delayed audio.
Original and Delayed
Inverts the delayed signal, causing the waves to cancel out periodically, instead of reinforcing the signal.
Invert
Indicates the amount of delay. The horizontal ruler (x-axis) represents time, and the vertical ruler
Delay graph
(y-axis) represents the length of delay.
Indicates the amount of feedback. The x-axis represents time, and the y-axis represents the
Feedback graph
percentage of feedback.
Restricts the graph to the length you specify so the effect loops repeatedly over the course of the
Loop Graphs
selection. Selecting this option lets you specify Period (how long the graph should be), Frequency (how fast the loop
should repeat), and Total Cycles (how many times you want the graph to loop in the given selection). These settings
interact; changing one changes the others. If Loop Graph is deselected, the graph equals the length of the entire
selection, so the effect doesn't loop.
Represents the number of milliseconds one channel is behind the other, creating a stereo
Stereo Curve Delay
phasing sound. Positive values delay the right channel, while negative values delay the left.
Echo effect
The Delay And Echo > Echo effect adds a series of repeated, decaying echoes to a sound. (For a single echo, use the
Delay effect instead.) You can create effects ranging from a Grand Canyon-type "Hello-ello-llo-lo-o" to metallic,
clanging drainpipe sounds by varying the delay amount. By equalizing the delays, you can change a room's charac-
teristic sound from one with reflective surfaces (creating echoes that sound brighter) to one that is almost totally
absorptive (creating echoes that sound darker).
Note: Make sure the audio file is long enough for the echo to end. If the echo is cut off abruptly before it fully decays,
undo the Echo effect, add several seconds of silence by choosing Generate > Silence, and then reapply the effect.
See also
"Applying effects in Edit View" on page 106
"Applying effects in Multitrack View" on page 107
"Use effect presets" on page 104
"Add preroll and postroll to effects previews" on page 107
Echo options
Left and Right Channel settings
• Specifies the number of milliseconds, beats, or samples between each echo. For example, a setting of
Delay Time
100 milliseconds results in a 1/10th-second delay between successive echoes.
• Determines the falloff ratio of an echo. Each successive echo tails off at a certain percentage less than
Feedback
the previous one. A decay setting of 0% results in no echo at all, while a decay of 100% produces an echo that never
gets quieter.
•
Sets the percentage of echoed (wet) signal to mix with the original (dry) signal in the final output.
Mix
Let you define these echo characteristics:
ADOBE AUDITION 3.0 124
User Guide