Dell OptiPlex 330 User Manual page 87

Remote Wake-Up
(Off default)
Suspend Mode
(S3 default)
Maintenance
Service Tag
SERR Message
(On default)
Load Defaults
Event Log
ASF Mode
This option allows the system to power up when a
network interface controller or remote wakeup-capable
modem receives a wake up signal.
On is the default setting. On w/ Boot to NIC will allow
the computer to attempt to boot from a network prior
to using the boot sequence.
NOTE:
Normally, the system can be powered up remotely
from suspend mode, hibernate mode, or when powered
off. When Low Power Mode (in the Power Management
menu) is enabled, the system can only be powered up
remotely from Suspend.
Sets the computer's suspend mode.
• S1 - A suspend state in which the computer is running
in a low-power mode.
• S3 - A suspend state in which the power is reduced or
turned off for many components; however, system
memory remains active.
Displays the service tag for your computer.
Some graphics cards require that the SERR message be
disabled.
Restores system setup options to their factory defaults.
Allows you to view the Event Log. Entries are marked R
for Read and U for Unread. Mark All Entries Read puts
an R to the left of all the entries. Clear Log clears the
Event Log.
Controls the NIC Alert Standard Format (ASF)
management. This BIOS setup option is used to select
the ASF 2.0 function, Alert Only or Off.
System Setup
87