Dell OptiPlex 330 User Manual page 105

H A R D - D I S K D R I V E R E A D F A I L U R E
(see "Contacting Dell" on page 267 for assistance).
K E Y B O A R D F A I L U R E
Problems" on page 120).
O B O O T D E V I C E A V A I L A B L E
N
partition.
• If the floppy drive is your boot device, ensure that the cables are connected and
that a bootable floppy disk is in the drive.
• If the hard drive is your boot device, ensure that the cables are connected and
that the drive is installed properly and partitioned as a boot device.
• Enter system setup and ensure that the boot sequence information is correct
(see "Entering System Setup" on page 79).
N O T I M E R T I C K I N T E R R U P T
malfunctioning or motherboard failure (see "Contacting Dell" on page 267 for
assistance).
N O N - S YS T E M D I S K O R D I S K E R R O R
has a bootable operating system or remove the floppy disk from drive A and restart
the computer.
N O T A B O O T D I S K E T T E
computer.
O V E R C U R R E N T E R R O R
USB
power source for the USB device.
— Possible HDD failure during HDD boot test
— Keyboard failure or keyboard cable loose (see "Keyboard
— The system cannot detect a bootable device or
— A chip on the system board might be
— Replace the floppy disk with one that
— Insert a bootable floppy disk and restart your
— Disconnect the USB device. Use an external
Troubleshooting Tools
105