Optical Drive - Dell OptiPlex 330 User Manual

See the documentation that came with the drive for instructions on
installing any software required for drive operation.
13 Enter system setup (see "Entering System Setup" on page 79) and select
the appropriate Diskette Drive option.
14 Verify that your computer works correctly by running the Dell Diagnostics
(see "Dell Diagnostics" on page 111).

Optical Drive

CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
CAUTION:
To guard against electrical shock, laceration by moving fan blades, or
other unexpected injuries, always unplug your computer from the electrical outlet
before removing the cover.
Removing an Optical Drive
1 Follow the procedures in "Before You Begin" on page 143.
NOTICE:
Do not pull the drive out of the computer by the drive cables. Doing so
may cause damage to cables and the cable connectors.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 209).
3 Pull up on the drive release latch and slide the drive towards the back of
the computer. Then, lift up to remove the drive from the computer.
4 Disconnect the optical drive data cable from the system board connector.
5 Disconnect the power cable and the optical drive data cable from the back
of the drive.
6 If you are replacing the optical drive, see "Optical Drive" on page 237.
7 If you are not replacing the drive, replace the drive panel insert.
8 Replace the computer cover (see "Replacing the Computer Cover" on
page 257).
NOTICE:
To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
Desktop Computer Parts
237