Testing The Configuration; Logging Out Of Smu; Next Steps - HP 2000fc User Manual

Testing the Configuration

To determine that your system is ready for use, test the configuration as follows:
1. In SMU, select Monitor > Vdisk Status and view the configuration information for
each virtual disk.
The virtual disk status is Critical during initialization but you can perform I/O to the
volume.
2. From the data host:
a. Make the volume an operating system partition.
b. Verify that you can access the mapped volume and the volume size shown on the
data host matches the size shown in SMU.
c. Verify that you can write data to the volume.
If the above tests succeed, your system is ready for use.
3. Once you have determined that your system is ready for use, tighten the thumb
screws on all SAS cables.
4. Optionally, unmount the volume and delete the test vdisks.

Logging Out of SMU

If you do not log out of SMU when you have finished using it, other
cannot log in to the same controller module and your IP address stays logged in for
30 minutes (the default auto-logout timeout setting).
To log out of SMU:
1. Click Log Off at the bottom of the menu.
The Log Off page is displayed.
2. Click Log Off.

Next Steps

You have completed the initial configuration tasks covered in this guide. For
additional information on configuring your system and performing administrative
tasks, refer to SMU's online help or the reference guide.
Chapter 4 Configuring a System for the First Time
users
manage
59