Japanese Power Cord Notice; Electrostatic Discharge; Preventing Electrostatic Damage; Grounding Methods - HP 2000fc User Manual

Japanese Power Cord Notice

Electrostatic Discharge

To prevent damage to the system, be aware of the precautions you need to follow
when setting up the system or handling parts. A discharge of static electricity from
a finger or other conductor may damage system boards or other static-sensitive
devices. This type of damage may reduce the life expectancy of the device.

Preventing Electrostatic Damage

To prevent electrostatic damage, observe the following precautions:
Avoid hand contact by transporting and storing products in static-safe containers.
■
Keep electrostatic-sensitive parts in their containers until they arrive at static-free
■
workstations.
Place parts on a grounded surface before removing them from their containers.
■
Avoid touching pins, leads, or circuitry.
■
Always be properly grounded when touching a static-sensitive component or
■
assembly (see "Grounding Methods" on page 71).

Grounding Methods

There are several methods for grounding. Use one or more of the following methods
when handling or installing electrostatic-sensitive parts:
Use a wrist strap connected by a ground cord to a grounded workstation or
■
computer chassis. Wrist straps are flexible straps with a minimum of 1 megohm
(±10 percent) resistance in the ground cords. To provide proper ground, wear the
strap snug against the skin.
Use heel straps, toe straps, or boot straps at standing workstations. Wear the
■
straps on both feet when standing on conductive floors or dissipating floor mats.
Use conductive field service tools.
■
Use a portable field service kit with a folding static-dissipating work mat.
■
If you do not have any of the suggested equipment for proper grounding, have an
HP authorized reseller install the part.
Appendix B Regulatory Compliance and Safety 71