MACROMEDIA DREAMWEAVER MX 2004-USING DREAMWEAVER Use Manual page 193

To move a layout cell:
Select a cell by clicking an edge of the cell or by Control-clicking (Windows) or
1
Command-clicking (Macintosh) anywhere in the cell.
Selection handles appear around the cell.
Do one of the following:
2
Drag the cell to another location within its layout table.
Press the arrow keys to move the cell 1 pixel at a time.
Tip: Hold down Shift while pressing an arrow key to move the cell 10 pixels at a time.
Resizing and moving layout tables
A layout table cannot be resized to be smaller than the smallest rectangle containing all of its cells.
A layout table also cannot be resized so that it overlaps other tables or cells.
To resize or move layout cells, see
To resize a layout table:
Select a table by clicking the tab at the top of the table.
1
Selection handles appear around the table.
Drag the selection handles to resize the table.
2
The table edges automatically snap to align with the edges of other cells and tables.
To move a layout table:
Select a table by clicking the tab at the top of the table.
1
Selection handles appear around the table.
Note: You can move a layout table only if it's nested inside another layout table.
Do one of the following:
2
Drag the table to another location on the page.
Press the arrow keys to move the table 1 pixel at a time.
Tip: Hold down Shift while pressing an arrow key to move the table 10 pixels at a time.
"Resizing and moving layout cells" on page
Resizing and moving layout cells and tables
192.
193