MACROMEDIA DREAMWEAVER MX 2004-USING DREAMWEAVER Use Manual page 169

To select a single column:
Click in the column.
1
Click the column header menu, then select Select Column.
2
Related topics
•
"Selecting a table" on page 168
Selecting cells
You can select a single cell, a line or block of cells, or nonadjacent cells. To select entire rows or
columns, see "Selecting rows or columns" on page
To select a single cell, do one of the following:
•
Click in the cell, then select the
Document window.
•
Control-click (Windows) or Command-click (Macintosh) in the cell.
•
Click in the cell, then select Edit > Select All.
Tip: Select Edit > Select All again when a cell is selected to select the entire table.
To select a line or a rectangular block of cells, do one of the following:
•
Drag from a cell to another cell.
•
Click in one cell, Control-click (Windows) or Command-click (Macintosh) in the same cell to
select it, then Shift-click another cell.
All of the cells within the linear or rectangular region defined by the two cells are selected.
To select nonadjacent cells:
•
Control-click (Windows) or Command-click (Macintosh) the cells, rows, or columns you
want to select.
If each cell, row, or column you Control-click or Command-click isn't already selected, it's
added to the selection. If it is already selected, it's removed from the selection.
Related topics
•
"Selecting a table" on page 168
168.
tag in the tag selector at the lower left corner of the
<td>
Selecting table elements 169