Simple Mail Transfer Protocol; Figure 3-18 Remote Logs - TP-Link TL-SG5426 Installation Manual

3
Configuring the Switch
• Host IP Address – Specifies a new server IP address to add to the Host IP List.
Web – Click System, Log, Remote Logs. To add an IP address to the Host IP List,
type the new IP address in the Host IP Address box, and then click Add. To delete
an IP address, click the entry in the Host IP List, and then click Remove.
CLI – Enter the syslog server host IP address, choose the facility type and set the
logging trap.
Console(config)#logging host 192.168.1.15
Console(config)#logging facility 23
Console(config)#logging trap 4
Console(config)#end
Console#show logging trap
Syslog logging:
REMOTELOG status:
REMOTELOG facility type:
REMOTELOG level type:
REMOTELOG server ip address: 192.168.1.15
REMOTELOG server ip address: 0.0.0.0
REMOTELOG server ip address: 0.0.0.0
REMOTELOG server ip address: 0.0.0.0
REMOTELOG server ip address: 0.0.0.0
Console#

Simple Mail Transfer Protocol

SMTP (Simple Mail Transfer Protocol) is used to send email messages between
servers. The messages can be retrieved using POP or IMAP clients.
Command Attributes
• Admin Status – Enables/disables the SMTP function. (Default: Enabled)
• Email Source Address – This command specifies SMTP servers email addresses
that can send alert messages.
3-28

Figure 3-18 Remote Logs

Enabled
Enabled
local use 7
Warning conditions
4-45
4-45
4-46
4-46