Mapping Ip Port Priority; Figure 3-92 Ip Port Priority Status - TP-Link TL-SG5426 Installation Manual

CLI – The following example globally enables DSCP Priority service on the switch,
maps DSCP value 0 to CoS value 1 (on port 1), and then displays the DSCP Priority
settings.
Console(config)#map ip dscp
Console(config)#interface ethernet 1/1
Console(config-if)#map ip dscp 1 cos 0
Console(config-if)#end
Console#show map ip dscp ethernet 1/1
DSCP mapping status: disabled
Port DSCP COS
--------- ---- ---
Eth 1/ 1 0
Eth 1/ 1 1
Eth 1/ 1 2
Eth 1/ 1 3
. .
.
Eth 1/ 1 61
Eth 1/ 1 62
Eth 1/ 1 63
Console#
* Mapping specific values for IP DSCP is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.

Mapping IP Port Priority

You can also map network applications to Class of Service values based on the IP
port number (i.e., TCP/UDP port number) in the frame header. Some of the more
common TCP service ports include: HTTP: 80, FTP: 21, Telnet: 23 and POP3: 110.
Command Attributes
• IP Port Priority Status – Enables or disables the IP port priority.
• IP Port Priority Table – Shows the IP port to CoS map.
• IP Port Number (TCP/UDP) – Set a new IP port number.
• Class of Service Value – Sets a CoS value for a new IP port. Note that "0"
represents low priority and "7" represent high priority.
Web – Click Priority, IP Port Priority Status. Set IP Port Priority Status to Enabled.
0
0
0
0
0
0
0

Figure 3-92 IP Port Priority Status

Class of Service Configuration
3
4-189
4-116
4-190
4-191
3-153