Static Multicast Routing Commands; Ip Igmp Snooping Vlan Mrouter; Table 4-70 Static Multicast Routing Commands - TP-Link TL-SG5426 Installation Manual

Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The switch must use IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Related Commands
ip igmp snooping version (4-203)

Static Multicast Routing Commands

Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter

ip igmp snooping vlan mrouter

This command statically configures a multicast router port. Use the no form to
remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4094)
• interface
• ethernet unit/port
- unit - Stack unit. (Range: Unit 1)
- port - Port number. (Range: 1-26)
• port-channel channel-id (Range: 1-4)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Table 4-70 Static Multicast Routing Commands
Function
Adds a multicast router port
Shows multicast router ports
Multicast Filtering Commands
Mode
GC
PE
4
Page
4-209
4-210
4-209