Mac-Address-Table Aging-Time - TP-Link TL-SG5426 Installation Manual

4
Command Line Interface
• sort - Sort by address, vlan or interface.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The MAC Address Table contains the MAC addresses associated with each
interface. Note that the Type field may include the following types:
- Learned - Dynamic address entries
- Permanent - Static entry
- Delete-on-reset - Static entry to be deleted when system is reset
• The mask should be hexadecimal numbers (representing an equivalent bit
mask) in the form xx-xx-xx-xx-xx-xx that is applied to the specified MAC
address. Enter hexadecimal numbers, where an equivalent binary bit "0"
means to match a bit and "1" means to ignore a bit. For example, a mask of
00-00-00-00-00-00 means an exact match, and a mask of
FF-FF-FF-FF-FF-FF means "any."
• The maximum number of address entries is 8191.
Example
Console#show mac-address-table
Interface Mac Address
--------- ----------------- ---- -----------------
Eth 1/1 00-12-cf-94-34-de
Trunk 2 00-12-cf-8f-aa-1b
Console#

mac-address-table aging-time

This command sets the aging time for entries in the address table. Use the no form
to restore the default aging time.
Syntax
mac-address-table aging-time seconds
no mac-address-table aging-time
seconds - Aging time. (Range: 10-30000 seconds; 0 to disable aging)
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The aging time is used to age out dynamically learned forwarding information.
4-142
Vlan Type
1 Delete-on-reset
1 Learned