Minolta PS7000 Operator's Manual page 32

11. SCSI connector:
12. Foot switch connector:
13. Power cord socket:
14. Power cord:
15. Foot switch (option):
16. Counter:
17. Angle book holder (option): Used to scan the original whose spine (binding part)
18. Stopper:
19. Center mark:
20. Size guide:
Connect the SCSI cable included in the interface kit.
When multiple SCSI devices are connected to the
personal computer, connect the Scanner at the end of the
SCSI chain. (Optional PC interface kit is required)
The total length of the SCSI cables must be 6 m or less
when used for daisy-chaining all the SCSI units alone or
3 m or less when used for daisy-chaining all the SCSI
units and SCSI-2 units.
Connect the foot switch (option) cable to this connector.
Use the left terminal (viewed from the rear) to read the
right page when the foot switch is pressed, and the right
terminal for the left page. Either terminal can be used
when reading two spread pages.
Plug the power cord into this socket.
Connects the Scanner to the power outlet.
Press this switch instead of the start key on the book
table to start scanning. Used when a large original is
covering the start key.
Counts the number of originals scanned.
should not be damaged (e.g., precious book).
Used as the reference position for the original. When
placing the original, align its top edge with this position.
Adjust the center of the original to this mark.
Indicates the scannable range of the original.
Part identification and functions
2-4