Minolta PS7000 Operator's Manual page 113

Pr version book scanner
Hide thumbs Also See for PS7000:
Table of Contents

Advertisement

5-3
Troubleshooting warning messages
Warning message
Book Size is Not Detected
Reset Book or Change Sheet
Right (Left) Size is Not
Detected
Reset Book or Change Sheet
Exp. level is Not Detected
Clean Top of Steel Mirror
Printer is OFF
Turn Printer ON
Paper Jam
Remove Paper on Drum (in
Take Up, in Fusing)
Paper Empty on Tray (in
Cassette)
Supply Paper
Toner Empty
Exchange Imaging Ctg
Printer Cover is OPEN
Close Printer Cover
Irregular Paper Size
Change Paper Size
Paper Size Error
Open and Close Cover
Possible cause
• The original is not set
correctly.
• No original is set.
• [Spread] is selected, but no
original is placed on the right
or left half of the book table.
• Change settings appropriately for the original, referring to "Notes on
originals".
• The shading plate is dirty.
• Your hands or arms were
placed over the original
during scanning.
• An obstacle is blocking the
lamp.
• The printer is not turned on.
• The printer is disconnected.
• Paper is jammed in the
printer.
• Out of paper.
• Out of toner.
• The printer cover is open.
• Wrong paper is selected.
• Paper inappropriate for the
printer is loaded in the printer.
• A paper fed into the printer is
the wrong size.
• More than one sheet of paper
is fed into the printer at the
same time.
Action
• Change settings appropriately for
the original, referring to "Notes
on originals".
• Set the original correctly.
• Select [Single] when scanning
only one page.
• Set the original correctly when
scanning a two page spread.
• Select the Sheet mode and cancel
the Auto function.
• Clean the shading plate.
• Never move your hands and arms
after the start switch is pressed.
• Remove the obstacle blocking the
lamp.
• Turn the printer on.
• Connect the printer.
• Open the printer cover and
remove the jammed paper.
• Supply correct paper.
• Replace the toner cartridge.
• Close the printer cover.
• Select the appropriate paper type.
• Supply paper appropriate for the
printer.
• Check the size of the paper set on
the tray and close the cover of the
printer.

Advertisement

Table of Contents
loading

Table of Contents