Installation and Setup
Overview of Installation Procedure
Camera Components and Functions
Installation
Selecting the Lens
14
Note
Please familiarize yourself with the installation procedure and complete each
step in the sequence given.
The initial installation of a network camera consists of the following steps:
Step
1
Select the lens.
2
Adjust the back focus.
3
Mount the camera.
4
Connect the camera.
5
Program the camera.
The network camera is intended for indoor use only. If you choose to mount the camera
outdoors, you must employ a suitable weatherproof enclosure (such as Honeywell's
HHC12 camera housing) with your network camera. See
information on Honeywell weatherproof enclosures and mounting brackets.
The network camera supports the use of a manual iris lens or DC (Direct Drive) iris lens.
When using a DC iris lens, it should be connected to the camera through the 4-pin square
socket located at the side of the camera (see
See ...
page 14
page 15
page 15
page 16
page 37
www.honeywellvideo.com
Figure
2-1).
for