Camera Blinding - Honeywell EQUIP HCD554IP Reference Manual

Camera Blinding

Document 800-00250 Rev C
08/08
2. In the Blur Threshold list, select one of the following options:
Table 4-6 Blur Threshold Values
Value
High (80%)
Medium (50%)
Low (30%)
3. Click Apply.
Note To turn off video blur detection, select Disable in the Blur Threshold list.
Disable is the default value.
Note You must click Apply for your changes to take effect. If you close the screen
before clicking Apply, all your new settings will be lost.
An obstacle in front of the camera lens can blind the camera. When this occurs, camera
blinding is detected and shows an alarm message above the video display (see
Figure 4-11). To detect camera blinding:
1. Click the Video Analytics tab.
2. In the Blinding Threshold list, select one of the following options:
Table 4-7 Blinding Threshold Values
Value
High (80%)
Medium (50%)
Low (30%)
3. Click Apply.
EQUIP Series IP Camera Reference Guide
To detect ...
Maximum video blurring. The alarm message appears when
the video display is blurred by 80% and above.
Medium video blurring. The alarm message appears when
the video display is blurred by 50% and above.
Minimum video blurring. The alarm message appears when
the video display is blurred by 30% and above.
To detect ...
Maximum blinding. The alarm message appears when the
camera is blinded by 80% and above.
Medium blinding. The alarm message appears when the
camera is blinded by 50% and above.
Minimum blinding. The alarm message appears when the
camera is blinded by 30% and above.
45