ROSE DISPLAYS ECONOSTAND WITH ANOQUICK Instruction Sheet

EconoStand™

Parts

End Caps
06-5525

Instructions For Assembly

Step 1

Assemble bottom holder bracket onto
lower pole section (this is the thicker
section of the pole).

Step 2

Screw pole onto baseplate. Tighten
securely.

Step 3

Place stand upright. Using thumbscrew
at top of pole, attach top holder
bracket onto pole top.

Step 4

Prepare edges of graphic. Place the
graphic on tablettop with one edge at
the table edge. Using the AnoQuick
Holder run it across the graphic edge,
crushing it slightly. Fig. 4 Push the
holder on the graphic.

Step 5

Slide AnoQuick Holder onto brackets.
Install endcaps after assembly to
brackets.

Step 6

Adjust height of stand as necessary.
TM
The AnoQuick and Econostand
Neither the manufacturer nor any sales agent may be held liable for injury,
loss or damage resulting from the use of these products.
Part#02INSEcono/AnoQuick
Revised-9.10.02
Instruction Sheet
AnoQuick
12A300
1
3
5
TM
are trademarks of Rose Displays, Ltd.
EconoStand
components
Pole
Bottom
Holder Bracket
Base Plate
Top
Holder Bracket
2
2a
4
6
35 Congress Street, Salem MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Top
Thumb
Screw