ROSE DISPLAYS ECONOFRAME WITH CABLE CLIP AND BALL CHAIN Instruction Sheet

EconoFrame

Parts

Cable Clips
06-5050

Instructions for Hanging

Step 1

Insert corner brackets into split rails and
into rail opposite split
rail. Split rail side is made up of
two separate pieces. Fig. 1
Note: Corner bracket tension tabs must
face toward inside
of frame.

Step 2

Insert single ball of ball chain into inner
channel of Cable Clip. The cable should
snap into place. Fig. 3

Step 3

Align one round end of cable clip with top
channel of the rail and insert. Once in
place, insert end of ball chain into chan-
nel. Then press down on the other round
end of the cable clip and slide into rail by
pushing on the clip. Fig. 4 Repeat steps 2
& 3 for second CableClip.
Note: Be sure to push on the cable clip
in order to slide the ball chain into place.
Do not pull on, or push against, the ball
chain as this will cause it to bind in the
channel.

Step 4

Assemble frame following steps in. Fig. 4
sliding sides together in the order shown.

Step 5

Insert poster. Fig 5.
The EconoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSEconoFrameCCBallChain
Incept-11.13.02
TM
Instruction Sheet
Corner EconoFrame rails
brackets
3
EconoFrame
12EF-100 split rails
Figure 1
Figure 2
solid rail w/
4
solid rail
Figure 4
Ball Chains
96-0302P
1 2
Figure 3
Figure 5
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com