Throtlle Cable - GAS GAS FSE 400 - 2004 Service Manual

- Clean the element in a
bath of a filter cleaning
fluid using a soft bristle
brush.
- Inspect the element for damage such as tears, hardening, or
shrinkage. If damaged, replace it or it will allow dirt into the carburetor.
- Install the element in the machine, and make sure the sealing
surface of the element is seated properly.

THROTLLE CABLE

- Inspect the throttle grip for smooth operation in all steering positions.In
accordance with the Periodic Maintenance Chart, check and adjust
the throttle cable.
- Check that the throttle grip has 2-3 mm of play and turns smoothly.
- Squeeze it dry in a
clean towel. Do not
wring the element or
blow it dry; the element
can be damaged.
- Apply grease to all
connections and srew
hole in the air cleaner
housing and intake
tract.
- If the play is incorrect, loosen the locknut on the upper end of the
throttle cable, and turn the adjuster to obtain the correct amount of
play. Tighten the locknut.
87
EC FSE 2004 - -
(C) (E) (B) (A)
(D)
(A). Adjuster.
(B). Locknut.
(C). Throttle grip.
(D). Brake fluid reservoir, rear.
(E). Choke Button.