GAS GAS FSE 400 - 2004 Service Manual page 53

0000
Total distance
To change the time:
- Press mode until time display is shown.
- Press mode again keeping the button pressed the hour will display
only add the hours by pressing the reset (top) button.
- Press mode again to adjust the minutes in the same way.
- Press mode again and the time is now set.
(when you have set the time the seconds automatically start from
zero )
Trip distance:
- From time display press mode 3 times. (l- 0) to zero the trip , keep
the reset button pressed until it zeros.
To change to kilometers per hour or miles per hour:
- Disconnect the battery. (the total distance will be saved).
- Re-connect the battery whilst holding down either button and it will
read either;
0.0
- The white plastic block connector on the speedo is for the display
backlight.
- The red wire is positve.
- The black wire is negative.
Trip distance
- Warning; your speedo is set for the diameter of your front wheel
If you get the display to read "a 00" then you are in the rolling radius
changing mode. you can "trim" the speed to run fast or slow.
It ranges from "a-25" to "a 25".
Standard setting is "a 00", we recommend you keep it at that.
117
EC FSE 2004 - -
met -- for km/h
mil --- for mp/h
enduro 21"
supermoto 17"
NOTE