Throtlle Cable - GAS GAS EC FSE 400 - 2003 Service Manual

- Clean the element in a
bath of a filter cleaning
fluid using a soft bristle
brush.
- Inspect the element for damage such as tears, hardening, or
shrinkage. If damaged, replace it or it will allow dirt into the carburetor.
- Install the element in the machine, and make sure the sealing
surface of the element is seated properly.
- Squeeze it dry in a
clean towel. Do not
wring the element or
blow it dry; the element
can be damaged.
- Apply grease to all
connections and srew
hole in the air cleaner
housing and intake
tract.
EC FSE 2003 -

THROTLLE CABLE

- Inspect the throttle grip for smooth operation in all steering positions.In
accordance with the Periodic Maintenance Chart, check and adjust
the throttle cable.
- Check that the throttle grip has 2-3 mm of play and turns smoothly.
(C)
(E)
(A). Adjuster.
(B). Locknut.
(C). Throttle grip.
(D). Brake fluid reservoir, rear.
(E). Choke Button.
- If the play is incorrect, loosen the locknut on the upper end of the
throttle cable, and turn the adjuster to obtain the correct amount of
play. Tighten the locknut.
25
-
(B)
(A)
(D)